Accuracy
Accuracy of guideways LFS
Data on the straightness, parallelism (differential measurement), length and positional tolerances of guideways are given in the following tables and figures, ➤ Figure to ➤ Figure.
The guideways are precision straightened and the tolerances are better than DIN EN 12020.
Length tolerance
Length | Tolerance | ||
|---|---|---|---|
L | |||
mm | mm | ||
Single-piece guideways | L ＜ 1 000 | ±2 | |
1 000 ≦ | L ＜ 2 000 | ±3 | |
2 000 ≦ | L ＜ 4 000 | ±4 | |
4 000 ≦ | L | ±5 | |
Multi-piece guideways | Total length L | ±0,1% | |
Straightness tolerance for guideways
Length of guideway | Tolerance | ||
|---|---|---|---|
t1 (contact face) | t2 (lateral) | ||
mm | mm | ||
L ＜ 1 000 | 0,5 | 0,2 | |
1 000 ≦ | L ＜ 2 000 | 1 | 0,3 |
2 000 ≦ | L ＜ 3 000 | 1,5 | 0,4 |
3 000 ≦ | L ＜ 4 000 | 2 | 0,5 |
4 000 ≦ | L ＜ 5 000 | 2,5 | 0,6 |
5 000 ≦ | L ＜ 6 000 | 3 | 0,7 |
6 000 ≦ | L ＜ 7 000 | 3,5 | 0,8 |
7 000 ≦ | L ＜ 8 000 | 4 | 0,9 |
Tolerances for guideways LFS, LFS..-C, LFS..-NZZ, LFSR..-ST
Guideway LFS..-F
Guideway LFS120
Guideway LFS..-M
Guideway LFS..-FH
Tolerances for H2 and h4
Tolerances for H2 and h4, see table, ➤ Figure and ➤ Figure.
Guideway | Tolerance for | |
|---|---|---|
H2 | h4 | |
mm | mm | |
LFS20 | +0,3 | –0,1 |
LFS25 | –0,1 | |
LFS25-M | ±0,25 | |
LFS32 | +0,2 | |
LFS32-C | +0,2 | |
LFS32-N | +0,2 | |
LFS32-F | +0,1 | |
LFS32-M | ±0,25 | |
LFS32-FH | +0,1 | |
LFS42-C | +0,2 | |
LFS42-F | +0,1 | |
LFS52 | +0,2 | |
LFS52-C | +0,2 | |
LFS52-NZZ | +0,2 | |
LFS52-F | +0,1 | |
LFS52-M | +0,5 | |
LFS52-FH | +0,1 | |
LFS86-C | +0,25 | |
LFS120 | +0,2 | |
Reference dimension for accuracy, dimension H2
Reference dimension for accuracy, dimension h4
